330 kV變壓器局部放電試驗加壓方式研究 

溫定筠，孫亞明，呂景順，張玉 
(國網甘肅省電力公司電力科學研究院，甘肅 蘭州 730050) 
 

摘 要： 針對330 kV 變壓器局放試驗，分析了試驗加壓方式并通過工程驗證得出變壓器低壓繞組額定電壓較高時，采用對稱加壓方法，試驗設備額定電壓可以降低為單邊加壓方案的一半，有利于提高工作效率。對稱加壓法試驗時，對變壓器高、低壓繞組之間絕緣及中、低壓繞組之間絕緣考核更為嚴格，低壓繞組端子耐受電壓情況更接近運行實際，有利于提高缺陷檢出率，保證設備的安全投運。
關鍵詞： 變壓器；局部放電試驗；單邊加壓；對稱加壓
中圖分類號：TM406 文獻標識碼：A 文章編號：1007-3175(2014)05-0023-03

Study on Pressurized Way of Partial Discharge Test for 330 kV Transformer 

WEN Ding-jun, SUN Ya-ming, LV Jing-shun, ZHANG Yu 
（Gansu Electric Power Research Institute, Lanzhou 730050, China） 
 

Abstract: For 330 kV transformer partial discharge test, this paper analyzed the pressurized way of tests. The engineering verified that when the rated voltage of transformers low-voltage winding was higher, the symmetrical pressurized method was adopted and the rated voltage of test equipment could be reduced to half of the unilateral pressurized scheme, in favor of the improvement of work efficiency. At the time of symmetrical pressurized test, the assessment of insulation between the high and the low voltage windings was more stringent, as well as the assessment of insulation between the medium and the low voltage windings. The withstand voltage of low voltage winding terminals ran closer to the actual situation, in favor of improving the defect detection rate and ensuring the safety operation of equipment.
        Key words: transformer; partial discharge test; unilateral pressure; symmetrical pressure

參考文獻
[1] 胡啟凡.變壓器試驗技術[M].北京：中國電力出版社，2010.
[2] 陳天翔，王寅仲，海世杰.電氣試驗[M].2版.北京：中國電力出版社，2008.
[3] 謝毓城.電力變壓器手冊[K].北京：機械工業出版社，2003.